Arduino Stepper Motor Make It Spin Continuously

Arduino - Stepper Motor

---

A Stepper Motor or a step motor is a brushless, synchronous motor, which divides a full rotation into a number of steps. Unlike a brushless DC motor, which rotates continuously when a fixed DC voltage is applied to it, a step motor rotates in discrete step angles.

The Stepper Motors therefore are manufactured with steps per revolution of 12, 24, 72, 144, 180, and 200, resulting in stepping angles of 30, 15, 5, 2.5, 2, and 1.8 degrees per step. The stepper motor can be controlled with or without feedback.

Imagine a motor on an RC airplane. The motor spins very fast in one direction or another. You can vary the speed with the amount of power given to the motor, but you cannot tell the propeller to stop at a specific position.

Now imagine a printer. There are lots of moving parts inside a printer, including motors. One such motor acts as the paper feed, spinning rollers that move the piece of paper as ink is being printed on it. This motor needs to be able to move the paper an exact distance to be able to print the next line of text or the next line of an image.

There is another motor attached to a threaded rod that moves the print head back and forth. Again, that threaded rod needs to be moved an exact amount to print one letter after another. This is where the stepper motors come in handy.

How a Stepper Motor Works?

A regular DC motor spins in only direction whereas a Stepper motor can spin in precise increments.

Stepper motors can turn an exact amount of degrees (or steps) as desired. This gives you total control over the motor, allowing you to move it to an exact location and hold that position. It does so by powering the coils inside the motor for very short periods of time. The disadvantage is that you have to power the motor all the time to keep it in the position that you desire.

All you need to know for now is that, to move a stepper motor, you tell it to move a certain number of steps in one direction or the other, and tell it the speed at which to step in that direction. There are numerous varieties of stepper motors. The methods described here can be used to infer how to use other motors and drivers which are not mentioned in this tutorial. However, it is always recommended that you consult the datasheets and guides of the motors and drivers specific to the models you have.

Components Required

You will need the following components −

• 1 × Arduino UNO board
• 1 × small bipolar stepper Motor as shown in the image given below
• 1 × LM298 driving IC

Procedure

Follow the circuit diagram and make the connections as shown in the image given below.

Sketch

Open the Arduino IDE software on your computer. Coding in the Arduino language will control your circuit. Open a new sketch File by clicking New.

Arduino Code

/* Stepper Motor Control */  #include <Stepper.h> const int stepsPerRevolution = 90; // change this to fit the number of steps per revolution // for your motor // initialize the stepper library on pins 8 through 11: Stepper myStepper(stepsPerRevolution, 8, 9, 10, 11);  void setup() {    // set the speed at 60 rpm:    myStepper.setSpeed(5);    // initialize the serial port:    Serial.begin(9600); }  void loop() {    // step one revolution in one direction:    Serial.println("clockwise");    myStepper.step(stepsPerRevolution);    delay(500);    // step one revolution in the other direction:    Serial.println("counterclockwise");    myStepper.step(-stepsPerRevolution);    delay(500); }        

Code to Note

This program drives a unipolar or bipolar stepper motor. The motor is attached to digital pins 8 - 11 of Arduino.

Result

The motor will take one revolution in one direction, then one revolution in the other direction.

smiththerecomed1949.blogspot.com

Source: https://www.tutorialspoint.com/arduino/arduino_stepper_motor.htm

Share this post